Recalls for 2002 Mazda MPV

There are currently 3 recalls for your car.


What Should You Do?

Bring your car to a dealer immediately. Recalls are issued because the defect might make the car unsafe in some way. Your nearby service center can help verify if the repairs can be performed free of charge.

Contact a Service Center

NHTSA Vehicle Safety Recalls


Recall Number: 04V234000

Recall Date: 05/19/2004

Component: VEHICLE SPEED CONTROL:CABLES

Problem Summary: ON CERTAIN MINIVANS EQUIPPED WITH CRUISE CONTROL, THE CRUISE CONTROL ACTUATOR CABLE MAY BE BROKEN DUE TO INSUFFICIENT STRENGTH (GROUP 1). ALSO INCLUDED ARE CERTAIN 2000-2001 MINIVANS EQUIPPED WITH CRUISE CONTROL BUILT BETWEEN MARCH 31, 1999 AND MARCH 31, 2001, THAT HAVE HAD THE CRUISE CONTROL REPAIRED AND POSSIBLY HAD A DEFECTIVE CABLE INSTALLED DURING THAT REPAIR (GROUP 2).

Consequence: IT IS POSSIBLE THAT THE BROKEN ACTUATOR CABLE MAY BE OUT OF POSITION AND COULD INTERFERE WITH THE OPERATION OF THE ACCELERATOR CABLE, PREVENTING A DECREASE IN ENGINE SPEED WHILE DRIVING, INCREASING THE RISK OF A CRASH.

What Owners Should Do: DEALERS WILL REPLACE THE ACTUATOR CABLE. OWNER NOTIFICATION FOR VEHICLES INVOLVED IN GROUP 1 BEGAN ON JULY 7, 2004. OWNER NOTIFICATION FOR VEHICLES INVOLVED IN GROUP 2 BEGAN ON SEPTEMBER 10, 2004. OWNERS SHOULD CONTACT MAZDA AT 1-800-222-5500.

Next Steps: Contact a Service Center Near You

Recall Number: 03V206000

Recall Date: 06/05/2003

Component: EXTERIOR LIGHTING:FOG LIGHTS

Problem Summary: ON CERTAIN MINI VANS AND PASSENGER VEHICLES, THE SOCKET HOLDER IN THE FOG LIGHTS IS INSTALLED IN THE LAMP CASING USING PRESSURE. DURING OPERATION OF THE FOG LIGHT, THE HEAT FROM THE BULB CAN EXPAND THE SOCKET HOLDER. THE EXPANSION CAN FORCE THE SOCKET HOLDER REARWARD. AFTER REPEATEDLY BEING SUBJECT TO THIS EXPANSION, IF THE FOG LIGHT IS ALSO SUBJECTED TO VIBRATION DURING VEHICLE OPERATION, THE SOCKET HOLDER WITH THE BULB HOLDER AND THE WIRING HARNESS MAY SEPARATE FROM THE FOG LIGHT CASING.

Consequence: SHOULD THIS OCCUR, THE BULB SOCKET AND THE HARNESS CAN DROP INSIDE THE BUMPER AND POSSIBLY BUT RARELY, THE HEAT GENERATED BY THE BULB CAN CAUSE THE BUMPER TO BURN.

What Owners Should Do: DEALERS WILL INSTALL A SPRING TO PREVENT THE SOCKET HOLDER FROM SEPARATING FROM THE LAMP CASE. OWNER NOTIFICATION BEGAN ON JULY 14, 2003. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT MAZDA AT 1-800-222-5500.

Next Steps: Contact a Service Center Near You

Recall Number: 03V053000

Recall Date: 02/13/2003

Component: EXTERIOR LIGHTING:FOG LIGHTS

Problem Summary: ON CERTAIN MINI VANS EQUIPPED WITH FRONT FOG LIGHTS,THE FOG LIGHT BULB SOCKET MAY HAVE BEEN INSTALLED IMPROPERLY.

Consequence: IF THE VEHICLE CONTINUES TO BE USED WITH THIS CONDITION, THE BULB SOCKET AND THE WIRING HARNESS MAY SEPARATE FROM THE FOG LIGHT HOUSING IF EXPOSED TO SHOCK AND/OR VIBRATION AND DROP INSIDE THE BUMPER. SHOULD THIS OCCUR, THE OPERATION OF THE FOG LIGHT MAY THEN CAUSE THE BUMPER TO BURN.

What Owners Should Do: DEALERS WILL INSPECT THE INSTALLATION CONDITION OF THE FOG LIGHT BULB ASSEMBLY, AND REPAIR IT WHEN NECESSARY. OWNER NOTIFICATION BEGAN MARCH 31, 2003. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT MAZDA AT 1-800-222-5500.

Next Steps: Contact a Service Center Near You

Certified Service Centers

Certification requires warranty on parts and labor, fair-price* guarantee, certified technicians and high customer satisfaction ratings.

*Fair prices, measured by comparing them to the RepairPal Price Estimator.

Additional terms and conditions apply