Recalls for 1993 Nissan Altima

There are currently 3 recalls for your car.


What Should You Do?

Bring your car to a dealer immediately. Recalls are issued because the defect might make the car unsafe in some way. Your nearby service center can help verify if the repairs can be performed free of charge.

Contact a Service Center

NHTSA Vehicle Safety Recalls


Recall Number: 10E002000

Recall Date: 02/11/2010

Component: SUSPENSION

Problem Summary: RIDE CONTROL IS RECALLING CERTAIN FRONT STRUT MOUNTS BRANDED AS GABRIEL RIDE CONTROL OR ARVINMERITOR, P/NOS. 142435, 142193, 142305, 142303, SOLD AS REPLACEMENT EQUIPMENT FOR THE VEHICLES LISTED ABOVE. THE AFFECTED FRONT STRUT MOUNTS DID NOT CONTAIN A WELD JOINT BETWEEN THE BEARING HOUSING AND THE RATE PLATE.

Consequence: THE ABSENCE OF THE WELD CAN ALLOW THE STRUT TO COME OUT OF ITS MOUNTING POSITION UNDER CERTAIN EXTREME DRIVING CONDITIONS WHICH COULD CAUSE DAMAGE TO SURROUNDING VEHICLE COMPONENTS INCREASING THE RISK OF A CRASH.

What Owners Should Do: RIDE CONTROL WILL NOTIFY OWNERS OF RECORD AND REPLACE THE AFFECTED PARTS FREE OF CHARGE. THE SAFETY RECALL IS EXPECTED TO BEGIN DURING MARCH 2010. OWNERS MAY CONTACT RIDE CONTROL AT 1-248-458-1396.

Next Steps: Contact a Service Center Near You

Recall Number: 06E026000

Recall Date: 03/23/2006

Component: EXTERIOR LIGHTING

Problem Summary: CERTAIN PRO-A MOTORS CORNER LAMPS, TURN SIGNALS, AND HEADLIGHTS SOLD AS REPLACEMENT LAMPS FOR USE ON CERTAIN PASSENGER VEHICLES LISTED ABOVE. SOME COMBINATION LAMPS THAT ARE NOT EQUIPPED WITH AMBER SIDE REFLECTORS FAIL TO CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT.

Consequence: WITHOUT THE AMBER REFLECTORS, THE VEHICLE WILL BE POORLY ILLUMINATED, POSSIBLY RESULTING IN A VEHICLE CRASH WITHOUT WARNING.

What Owners Should Do: PRO-A MOTORS WILL NOTIFY OWNERS AND OFFER TO REPURCHASE THE LAMPS. THE RECALL BEGAN ON APRIL 3, 2006. OWNERS MAY CONTACT PRO-A MOTORS AT 323-838-2988.

Next Steps: Contact a Service Center Near You

Recall Number: 94V035000

Recall Date: 02/28/1994

Component: VEHICLE SPEED CONTROL

Problem Summary: ENGINE MOVEMENT CAN BE TRANSMITTED TO THE AIRFLOW METER/FILTER HOUSING AND SUPPORT BRACKET, WHICH IS MOUNTED IN THE ENGINE AIR DUCT, CAUSING THE THROTTLE CABLE HOUSING TO PULL OUT OF THE CABLE GUIDE. THIS MAY PREVENT THE THROTTLE FROM RETURNING TO THE IDLE POSITION WHEN THE GAS PEDAL IS RELEASED.

Consequence: IF THIS WERE TO OCCUR WHILE THE VEHICLE IS IN MOTION, LOSS OF THROTTLE CONTROL COULD RESULT IN AN ACCIDENT.

What Owners Should Do: NISSAN WILL REPOSITION THE THROTTLE CABLE HOUSING IN THE SUPPORT BRACKET TO PROVIDE ADDITIONAL SLACK FOR ENGINE MOVEMENT. A RUBBER STOPPER WILL BE CLAMPED TO THE CABLE TO MAINTAIN THE CORRECT POSITION FOR THE CABLE AT THE SUPPORT BRACKET. IN ADDITION, THE THROTTLE CABLE WILL BE TESTED FOR PULL OUT RESISTANCE FROM THE GUIDE IN THE EVENT THE CABLE WAS DAMAGED. THE THROTTLE ASSEMBLY WILL BE REPLACED, IF NECESSARY.

Next Steps: Contact a Service Center Near You

Certified Service Centers

Certification requires warranty on parts and labor, fair-price* guarantee, certified technicians and high customer satisfaction ratings.

*Fair prices, measured by comparing them to the RepairPal Price Estimator.

Additional terms and conditions apply