Honda is recalling certain model year 2007 through 2011 Element passenger vehicles equipped with an accessory trailer hitch wiring harness. The wire that supplies power to the trailer turn signal lights was inadvertently switched with the stop lamp wire. As a result the turn signals only illuminate when the brake lamps are illuminated. This does not comply with the requirements of Federal Motor Vehicle Safety Standard No. 108, "Lamps, Reflective Devices, and Associated Equipment."
HONDA IS RECALLING CERTAIN MODEL YEAR 2005-2010 ACCORD, 2007-2010 CR-V, AND 2005-2008 ELEMENT PASSENGER CARS MANUFACTURED FROM JULY 1, 2004, THROUGH SEPTEMBER 3, 2010. THE OUTER RACE OF THE SECONDARY SHAFT BEARING MAY BE BROKEN DURING CERTAIN DRIVING STYLES. A BROKEN OUTER RACE MAY CAUSE ABNORMAL NOISE, THE MALFUNCTION INDICATOR LIGHT TO TURN ON, AND ALLOW CONTACT BETWEEN THE TRANSMISSION IDLE GEAR AND AN ELECTRONIC SENSOR HOUSING WITHIN THE TRANSMISSION.
Honda (American Honda Motor Co.) is recalling certain model year 2001-2007 Accord, 2001-2005 Civic, 2001-2004 Honda Civic GX, 2003-2005 Honda Civic Hybrid, 2002-2006 CR-V, 2003-2011 Element, 2002-2004 Odyssey, 2003-2008 Pilot, 2006 Ridgeline, 2003 Acura 3.2CL, 2003-2006 Acura MDX, and 2002-2003 Acura 3.2TL vehicles. The affected vehicles are equipped with a dual-stage driver frontal air bag that may be susceptible to moisture intrusion and other factors, including manufacturing variability that, over time, could cause the inflator to rupture.
HONDA HAS NOTIFIED NHTSA OF A DEFECT IN CERTAIN MODEL YEAR 2007 AND 2008 ODYSSEY AND ELEMENT PASSENGER VEHICLES MANUFACTURED BETWEEN JULY 28, 2006 AND AUGUST 21, 2008. AIR CAN ENTER THE VSA MODULAR PUMP DURING AN INITIAL SELF-CHECK PROCESS THAT OCCURS SHORTLY AFTER EACH TIME THE ENGINE IS STARTED. IT IS POSSIBLE FOR ENOUGH AIR TO ENTER THE SYSTEM TO RESULT IN A BRAKE PEDAL THAT FEELS SOFT OR LOWER TO THE FLOOR.
HONDA IS RECALLING 241 MY 2008 ELEMENT VEHICLES. THE FRONT BUSHING BRACKET OF THE LEFT TRAILING ARM OF THE REAR SUSPENSION MAY HAVE BEEN IMPROPERLY WELDED AND COULD SEPARATE FROM THE TRAILING ARM.
ALL IN ONE MOBILITY IS RECALLING CERTAIN MODEL YEAR 1997 THROUGH 2008 CONVERSION VANS EQUIPPED WITH VMI/RICON 6-WAY POWER SEAT BASES. THERE IS A POSSIBILITY OF A DEFECTIVE WELD AT THE JOINT BETWEEN THE PIVOTING PLATE AND THE PIVOTING PLATE PIN.
Honda (American Honda Motor Co.) is recalling certain model year 2003-2006 Acura MDX, 2005-2011 Acura RL, 2005-2006 Honda CR-V, 2003-2011 Element, 2007-2008 Fit, 2003-2008 Pilot, 2002-2004 Odyssey, and 2006-2011 Ridgeline vehicles originally sold, or that have ever been registered, in Alabama, California, Florida, Georgia, Hawaii, Louisiana, Mississippi, South Carolina, Texas, Puerto Rico, American Samoa, Guam, the Northern Mariana Islands (Saipan), and the U.S. Virgin Islands, or "Zone A." Additionally, unless included in "Zone A" above, Honda is recalling certain model year 2003-2006 Acura MDX, 2005-2008 Acura RL, 2005-2006 Honda CR-V, 2003-2008 Element, 2007-2008 Fit, 2003-2008 Pilot, 2002-2004 Odyssey, and 2006-2008 Ridgeline vehicles originally sold, or that have ever been registered, in Arizona, Arkansas, Delaware, District of Columbia, Illinois, Indiana, Kansas, Kentucky, Maryland, Missouri, Nebraska, Nevada, New Jersey, New Mexico, North Carolina, Ohio, Oklahoma, Pennsylvania, Tennessee, Virginia, and West Virginia, or "Zone B." Lastly, unless included in "Zone A" or "Zone B" above, Honda is recalling model year 2002-2004 Odyssey and model year 2003-2004 Acura MDX, Honda Element, and Honda Pilot vehicles originally sold, or registered, in Alaska, Colorado, Connecticut, Idaho, Iowa, Maine, Massachusetts, Michigan, Minnesota, Montana, New Hampshire, New York, North Dakota, Oregon, Rhode Island, South Dakota, Utah, Vermont, Washington, Wisconsin, and Wyoming. These vehicles are equipped with certain air bag inflators assembled as part of the passenger frontal air bag modules, and used as original equipment or replacement equipment. In the event of a crash necessitating deployment of the front air bags, these inflators may rupture due to propellant degradation occurring after long-term exposure to absolute humidity and temperature cycling.
Contact your dealer as soon as possible Every recall is serious, so it’s important that you contact an authorized service center as soon as possible to make an appointment to get it fixed.
Need to make other repairs? Get repair estimates at service centers near you.