2000 Mazda B4000 Recalls

There are currently 3 recalls for your vehicle. Change vehicle

NHTSA Vehicle Safety Recalls

  • Recall Number
    07V347000
    Recall Date
    08/07/2007
    Component
    VEHICLE SPEED CONTROL
    Summary

    ON CERTAIN TRUCKS EQUIPPED WITH A SPEED CONTROL SYSTEM, THE SPEED CONTROL DEACTIVATION SWITCH MAY, UNDER CERTAIN CONDITIONS, LEAK INTERNALLY AND THEN OVERHEAT, SMOKE, OR BURN.

    Consequence

    THIS COULD RESULT IN AN UNDERHOOD FIRE.

    What Owners Should Do

    DEALERS WILL INSTALL A FUSED WIRING HARNESS. AN INTERIM NOTICE WAS SENT TO OWNERS ON SEPTEMBER 7, 2007, DIRECTING THEM TO HAVE THE SPEED DEACTIVATION CONTROL SWITCH DISCONNECTED TEMPORARILY. A SECOND NOTIFICATION LETTER TO OWNERS WAS IN FEBRUARY 2008 ADVISING THEM TO RETURN TO DEALERS FOR INSTALLATION OF THE REPAIR PART. OWNERS OF AFFECTED VEHICLES WHO DID NOT RECEIVE A PHASE 2 NOTICE AND HAVE NOT HAD THE RECALL COMPLETED WILL BE NOTIFIED BEGINNING AUGUST 6, 2008. OWNERS MAY CONTACT MAZDA AT 1-800-222-5500.

  • Recall Number
    00T005000
    Recall Date
    08/21/2000
    Component
    TIRES:TREAD/BELT
    Summary

    TIRE DESCRIPTION: FIRESTONE WILDERNESS AT, SIZE P235/75R15, PRODUCED AT THE DECATUR, ILLINOIS TIRE PLANT AND ALL FIRESTONE RADIAL ATX AND RADIAL ATX II TIRES, SIZE P235/75R15. OPERATION OF THESE TIRES AT LOW INFLATION PRESSURES, HIGH SPEED, AND IN HOT WEATHER, CAN CONTRIBUTE TO SEPARATION OF THE TIRE TREAD.

    Consequence

    IF THE TREAD SEPARATES FROM THE TIRE, THE DRIVER CAN LOSE CONTROL OF THE VEHICLE, POSSIBLY RESULTING IN A CRASH CAUSING INJURY OR DEATH.

    What Owners Should Do

    THE REPLACEMENT/REIMBURSEMENT PROGRAM FOR THIS CAMPAIGN EXPIRED ON AUGUST 29, 2001. HOWEVER, CUSTOMERS SHOULD CONTACT FIRESTONE CUSTOMER SERVICE AT 1-800-465-1904 FOR POSSIBLE ASSISTANCE.

  • Recall Number
    00V228002
    Recall Date
    08/18/2000
    Component
    SEAT BELTS
    Summary

    VEHICLE DESCRIPTION: LIGHT DUTY TRUCKS EQUIPPED WITH TRW SEAT BELT BUCKLE ASSEMBLIES. THE BUCKLE BASE OF THESE SEAT BELT ASSEMBLIES WERE NOT PROPERLY HEAT TREATED AND THEREFORE DO NOT PASS THE LOAD BEARING REQUIREMENT OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 209, "SEAT BELT ASSEMBLIES."

    Consequence

    IN THE EVENT OF A VEHICLE CRASH, THE OCCUPANT MAY NOT BE PROPERLY RESTRAINED.

    What Owners Should Do

    DEALERS WILL INSPECT THE BUCKLE ASSEMBLIES TO DETERMINE WHETHER THE BUCKLE ASSEMBLY BUILD DATE CODES ARE WITHIN THE SUSPECT RANGE. THOSE WITHIN THE SUSPECT DATE CODE RANGE WILL BE REPLACED.

What Should You Do?

Contact your dealer as soon as possible
Every recall is serious, so it’s important that you contact an authorized service center as soon as possible to make an appointment to get it fixed.