1993 Nissan Altima Recalls

There are currently 3 recalls for your vehicle. Change vehicle

NHTSA Vehicle Safety Recalls

  • Recall Number
    10E002000
    Recall Date
    02/11/2010
    Component
    SUSPENSION
    Summary

    RIDE CONTROL IS RECALLING CERTAIN FRONT STRUT MOUNTS BRANDED AS GABRIEL RIDE CONTROL OR ARVINMERITOR, P/NOS. 142435, 142193, 142305, 142303, SOLD AS REPLACEMENT EQUIPMENT FOR THE VEHICLES LISTED ABOVE. THE AFFECTED FRONT STRUT MOUNTS DID NOT CONTAIN A WELD JOINT BETWEEN THE BEARING HOUSING AND THE RATE PLATE.

    Consequence

    THE ABSENCE OF THE WELD CAN ALLOW THE STRUT TO COME OUT OF ITS MOUNTING POSITION UNDER CERTAIN EXTREME DRIVING CONDITIONS WHICH COULD CAUSE DAMAGE TO SURROUNDING VEHICLE COMPONENTS INCREASING THE RISK OF A CRASH.

    What Owners Should Do

    RIDE CONTROL WILL NOTIFY OWNERS OF RECORD AND REPLACE THE AFFECTED PARTS FREE OF CHARGE. THE SAFETY RECALL IS EXPECTED TO BEGIN DURING MARCH 2010. OWNERS MAY CONTACT RIDE CONTROL AT 1-248-458-1396.

  • Recall Number
    06E026000
    Recall Date
    03/23/2006
    Component
    EXTERIOR LIGHTING
    Summary

    CERTAIN PRO-A MOTORS CORNER LAMPS, TURN SIGNALS, AND HEADLIGHTS SOLD AS REPLACEMENT LAMPS FOR USE ON CERTAIN PASSENGER VEHICLES LISTED ABOVE. SOME COMBINATION LAMPS THAT ARE NOT EQUIPPED WITH AMBER SIDE REFLECTORS FAIL TO CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT.

    Consequence

    WITHOUT THE AMBER REFLECTORS, THE VEHICLE WILL BE POORLY ILLUMINATED, POSSIBLY RESULTING IN A VEHICLE CRASH WITHOUT WARNING.

    What Owners Should Do

    PRO-A MOTORS WILL NOTIFY OWNERS AND OFFER TO REPURCHASE THE LAMPS. THE RECALL BEGAN ON APRIL 3, 2006. OWNERS MAY CONTACT PRO-A MOTORS AT 323-838-2988.

  • Recall Number
    94V035000
    Recall Date
    02/28/1994
    Component
    VEHICLE SPEED CONTROL
    Summary

    ENGINE MOVEMENT CAN BE TRANSMITTED TO THE AIRFLOW METER/FILTER HOUSING AND SUPPORT BRACKET, WHICH IS MOUNTED IN THE ENGINE AIR DUCT, CAUSING THE THROTTLE CABLE HOUSING TO PULL OUT OF THE CABLE GUIDE. THIS MAY PREVENT THE THROTTLE FROM RETURNING TO THE IDLE POSITION WHEN THE GAS PEDAL IS RELEASED.

    Consequence

    IF THIS WERE TO OCCUR WHILE THE VEHICLE IS IN MOTION, LOSS OF THROTTLE CONTROL COULD RESULT IN AN ACCIDENT.

    What Owners Should Do

    NISSAN WILL REPOSITION THE THROTTLE CABLE HOUSING IN THE SUPPORT BRACKET TO PROVIDE ADDITIONAL SLACK FOR ENGINE MOVEMENT. A RUBBER STOPPER WILL BE CLAMPED TO THE CABLE TO MAINTAIN THE CORRECT POSITION FOR THE CABLE AT THE SUPPORT BRACKET. IN ADDITION, THE THROTTLE CABLE WILL BE TESTED FOR PULL OUT RESISTANCE FROM THE GUIDE IN THE EVENT THE CABLE WAS DAMAGED. THE THROTTLE ASSEMBLY WILL BE REPLACED, IF NECESSARY.

What Should You Do?

Contact your dealer as soon as possible
Every recall is serious, so it’s important that you contact an authorized service center as soon as possible to make an appointment to get it fixed.