Nissan Recalls

On certain passenger and sport utility vehicles, the clock spring electrical connector may not be fully secured to the driver air bag module squib pin connector. If the connector comes loose, the driver air bag will not deploy in a crash, increasing the risk of injury.

On certain MY 2000-2002 passenger vehicles equipped with the QG18DE engine and MY 2002-2003 passenger vehicles equipped with QR25DE engines, the foam material used for the interior lining of the Electronic Control Module (ECM) box emits sulfur as it cures. If one of the resistors inside the ECM has a crack on the surface coating, the gas may cause corrosion of the resistor. This could cause the Malfunction Indictor Light to come on, poor drivability (idle instability, poor accelerator), or the engine to stop running during vehicle operation, which could result in a crash.

Certain passenger vehicles fail to comply with requirements of Federal Motor Vehicle Safety Standard No. 108, "Lamps, Reflective Devices, and Associated Equipment." Vehicles produced during this period were missing tamperproof caps that prevent horizontal headlamp adjustment.

On certain passenger vehicles, one or more of the three bolts used to attach each front suspension lower control arm to the body on the left and right sides may not have been properly manufactured and could fracture, increasing the risk of a crash.

On certain passenger vehicles equipped with a Nissan-approved accessory floor mat that was installed either at the assembly plant or by the dealer, due to the length of the driver side floor mat, a small amount of mat movement could cause the mat to interfere with the accelerator pedal and not allow the pedal to release after it is depressed. If this occurs unexpectedly, it could lead to a crash.

Nissan North America, Inc. (Nissan) is recalling certain 2020-2026 Nissan Armada, 2011-2013 Infiniti QX56, and 2014-2027 QX80 vehicles equipped with 22" wheels. The Gross Axle Weight Rating (GAWR) listed on the certification label is incorrect, which can allow the vehicle to be overloaded. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard number 110, "Tire Selection and Rims."

Nissan North America, Inc. (Nissan) is recalling certain 2026 Rogue vehicles. The instrument panel may not display the transmission gear selection indicator. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard number 102, "Transmission Shift Lever Sequence, Starter Interlock, and Transmission Braking Effect."

Nissan North America, Inc. (Nissan) is recalling certain 2025 Nissan Sentra vehicles. The front left-side driveshaft may not be fully seated in the continuously variable transmission (CVT) assembly, which can cause a transmission fluid leak and loss of drive power.

Nissan North America, Inc. (Nissan) is recalling certain 2025-2026 Kicks vehicles. A software error in the combination meter may cause the screen display to go partially or fully blank. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard number 101, "Control and Displays."

Nissan North America, Inc. (Nissan) is recalling certain 2026 Kicks and Sentra vehicles. The hook bracket of the front seat frames may be insufficiently welded, which can cause the front seat frames to become loose. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard (FMVSS) numbers 207, "Seating Systems" and 210, "Seat Belt Assembly Anchorages."