Honda Civic Hybrid Recalls

Honda is recalling certain model year 2001-2003 Civic, model year 2002-2003 CR-V, and model year 2002 Odyssey vehicles to address a safety defect in the passenger side frontal air bag which may produce excessive internal pressure causing the inflator to rupture upon deployment of the air bag. This recall addresses both the passenger side frontal air bags that were originally installed in the vehicles, as well as replacement air bags that may have been installed as replacement service parts. A replacement air bag may have been installed, as one example, if a vehicle had been in a crash necessitating the replacement of the passenger side frontal air bag.

HONDA IS RECALLING CERTAIN MODEL YEAR 2012 HONDA CIVIC VEHICLES. DURING ASSEMBLY, THE PROCESS REQUIRED TO SEAT THE DRIVER?S SIDE DRIVESHAFT AND SET THE RETAINING CLIP WAS NOT COMPLETED. AS A RESULT, THE DRIVESHAFT MAY SEPARATE.

HONDA IS RECALLING CERTAIN MODEL YEAR 2012 CIVIC 2-DOOR AND 4-DOOR VEHICLES MANUFACTURED FROM APRIL 21, 2011, THROUGH MAY 2, 2011. THERE IS A POSSIBILITY THAT AN O-RING, WHICH SEALS A CONNECTION IN THE FUEL FEED LINE, IS MISALIGNED. IF THE O-RING IS MISALIGNED, A SMALL FUEL LEAK MAY OCCUR.

HONDA IS RECALLING CERTAIN MODEL YEAR 2011 HONDA CIVIC VEHICLES. TO PREVENT FUEL FROM LEAKING OUT OF A VEHICLE'S FUEL TANK INTO THE EVAPORATIVE EMISSIONS CANISTER IN THE EVENT A ROLL-OVER INCIDENT OCCURS, THE FUEL PUMP MODULE IS EQUIPPED WITH A ROLL OVER VALVE (ROV). DUE TO IMPROPER ULTRASONIC WELDING OF THE PLASTIC CASE THAT HOUSES THE ROV WITHIN THE FUEL PUMP MODULE, THE CASE MATERIAL MAY BREAK OR CRACK, WHICH MAY CAUSE THE ROV TO SEPARATE FROM THE CASE AND FAIL TO FUNCTION, THEREBY INCREASING THE RISK OF FUEL LEAKAGE IN A ROLL-OVER INCIDENT.

ON CERTAIN VEHICLES, THE WHEEL SPEED SENSOR HOUSING USES AN O-RING SEAL TO PREVENT LEAKAGE TO OR FROM THE WHEEL BEARING. IF ASSEMBLED IMPROPERLY, THE O-RING MAY NOT SEAL PROPERLY ALLOWING WATER TO ENTER THE WHEEL BEARING AND EVENTUALLY CAUSE DAMAGE TO THE BEARING, ESPECIALLY IN AREAS WHERE USE OF ROAD SALT IS PREVALENT. IF THE DRIVER CONTINUES TO DRIVE WITH THIS CONDITION IT IS POSSIBLE FOR THE WHEEL BEARING TO BECOME LOOSE, WHICH COULD CAUSE THE BEARING TO FAIL.

ON CERTAIN SEDAN AND HYBRID VEHICLES, DURING ASSEMBLY, THE TELESCOPIC STEERING COLUMN MECHANISM MAY HAE BEEN OVER-LUBRICATED WITH SILICONE GREASE. OVER TIME, SOME OF THIS EXTRA GREASE MAY DRIP ON THE BRAKE LIGHT SWITCH AND THE SWITCH MAY FAIL.

ON CERTAIN PASSENGER VEHICLES, CERTAIN PARTS OF THE INTEGRATED MOTOR ASSIST (IMA) SYSTEM ARE LOCATED UNDER A METAL COVER BEHIND THE REAR SEAT-BACK. OVER TIME THE WEIGHT OF REAR SEAT PASSENGERS MAY CAUSE THE METAL COVER TO COME INTO CONTACT WITH A RUBBER CAP COVERING AN ELECTRICAL TERMINAL. THE RUBBER CAP MAY GET PINCHED, EXPOSING THE ELECTRICAL TERMINAL.

ON CERTAIN PASSENGER VEHICLES AND MOTORCYCLES, THE OWNER'S MANUALS CONTAIN INCORRECT CONTACT INFORMATION FOR THE NATIONAL HIGHWAY TRAFFIC SAFETY ADMINISTRATION'S (NHTSA) VEHICLE SAFETY HOTLINE.

ON CERTAIN PASSENGER VEHICLES, SOME FRONT SEAT BELT ANCHORS MAY HAVE BEEN INSTALLED WITH AN INCORRECT WASHER, WHICH COULD RESTRICT ANCHOR MOVEMENT. AS A RESULT, THE SEAT BELT MAY BE IMPROPERLY POSITIONED FOR CERTAIN OCCUPANTS.