Honda Recalls

ON CERTAIN VEHICLES, THE WHEEL SPEED SENSOR HOUSING USES AN O-RING SEAL TO PREVENT LEAKAGE TO OR FROM THE WHEEL BEARING. IF ASSEMBLED IMPROPERLY, THE O-RING MAY NOT SEAL PROPERLY ALLOWING WATER TO ENTER THE WHEEL BEARING AND EVENTUALLY CAUSE DAMAGE TO THE BEARING, ESPECIALLY IN AREAS WHERE USE OF ROAD SALT IS PREVALENT. IF THE DRIVER CONTINUES TO DRIVE WITH THIS CONDITION IT IS POSSIBLE FOR THE WHEEL BEARING TO BECOME LOOSE, WHICH COULD CAUSE THE BEARING TO FAIL.

CERTAIN MAXZONE HEADLIGHT ASSEMBLIES, DEPO BRAND, P/NOS. 317-1131L-AS, 317-1131R-AS, 317-1131L-US, AND 317-1131R-US, SOLD FOR USE AS AFTERMARKET EQUIPMENT FOR THE ABOVE LISTED PASSENGER VEHICLES. DURING PRODUCTION A SLIGHT DISTORTION OF THE BEZEL CHANGED THE LUMINOUS INTENSITY OF THE TURN SIGNAL. THESE HEADLAMPS FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT.

ON CERTAIN VEHICLES, A COIL WIRE INSIDE THE FUEL PUMP RELAY MAY BREAK, CAUSING THE FUEL PUMP TO LOSE POWER. IF THE FUEL PUMP BECOMES INOPERATIVE, THE ENGINE MAY NOT START.

ON CERTAIN PASSENGER VEHICLES, CERTAIN PARTS OF THE INTEGRATED MOTOR ASSIST (IMA) SYSTEM ARE LOCATED UNDER A METAL COVER BEHIND THE REAR SEAT-BACK. OVER TIME THE WEIGHT OF REAR SEAT PASSENGERS MAY CAUSE THE METAL COVER TO COME INTO CONTACT WITH A RUBBER CAP COVERING AN ELECTRICAL TERMINAL. THE RUBBER CAP MAY GET PINCHED, EXPOSING THE ELECTRICAL TERMINAL.

ON CERTAIN VEHICLES, THE SEAT POSITION SENSOR (SPS) DETECTS THE DRIVER'S SEATING POSITION AND ADJUSTS THE AIR BAG INFLATION PRESSURE ACCORDINGLY. THE WIRING HARNESS FOR THE SPS WAS ATTACHED TO THE SEAT FRAME IN THE WRONG LOCATION AND MAY HAVE BEEN OVER TIGHTENED. THE SENSOR WIRE MAY BREAK AND CAUSE THE AIR BAG WARNING LIGHT TO BE ILLUMINATED, AND THE SPS TO FAIL.

ON CERTAIN 2-DOOR PASSENGER VEHICLES, THE REAR WINDSHIELD OR REAR QUARTER GLASS PANELS DO NOT PROPERLY ADHERE TO THE BODY OF THE CAR DUE TO IMPROPER WINDOW OPENING PREPARATION.

ON CERTAIN PASSENGER VEHICLES AND MOTORCYCLES, THE OWNER'S MANUALS CONTAIN INCORRECT CONTACT INFORMATION FOR THE NATIONAL HIGHWAY TRAFFIC SAFETY ADMINISTRATION'S (NHTSA) VEHICLE SAFETY HOTLINE.

ON CERTAIN PASSENGER VEHICLES, THE TIRES COULD HAVE BEEN DAMAGED WHEN THE TIRES WERE MOUNTED ON THE WHEELS. IN CERTAIN CIRCUMSTANCES, THE BEAD AREA OF THE TIRE MAY HAVE BEEN DAMAGED.

ON CERTAIN PASSENGER VEHICLES, ON THE FRONTAL AIRBAG SYSTEM WHERE THE TWO EXTERNAL IMPACT SENSORS IS MOUNTED, NEAR THE FRONT HEADLIGHTS THE FRONT IMPACT SENSOR BOLTS WERE NOT PROPERLY TORQUED.

CERTAIN HONDA ACCESSORY TRAILER HARNESS KIT, P/N 08L91-SCV-102, MANUFACTURED BETWEEN NOVEMBER 24 AND DECEMBER 18, 2004, SOLD FOR USE ON MY 2005 HONDA ELEMENT VEHICLES MANUFACTURED BETWEEN DECEMBER 20, 2004, AND APRIL 29, 2005. THE WIRE HARNESS OF THE TRAILER HITCH KIT HAS AN INCORRECTLY WIRED CONNECTOR. AS A RESULT, THE TRAILER BRAKE LAMPS AND TURN SIGNAL LAMPS COULD OPERATE INCORRECTLY, OR A FUSE COULD BLOW CAUSING A SUDDEN LOSS OF BRAKE AND TURN SIGNAL LAMP FUNCTION.