Pontiac Recalls

GM IS RECALLING 35,038 MY 2008-2009 PONTIAC G8 VEHICLES FOR FAILING TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT" AND FEDERAL MOTOR VEHICLES SAFETY STANDARD NO. 138, "TIRE PRESSURE MONITORING SYSTEMS". THE BRAKE PEDAL POSITION SWITCH MAY HAVE BEEN INCORRECTLY PROGRAMMED. WITH THIS CONDITION, THE BRAKE LAMPS MAY BE CONTINUALLY ILLUMINATED AND FAIL TO WARN A FOLLOWING DRIVER WHEN THE VEHICLE IS BRAKING. ALSO CERTAIN VEHICLES MAY HAVE INCORRECT VALUES PROGRAMMED INTO THE TIRE PRESSURE MONITORING SYSTEM THAT WILL NOT ILLUMINATE THE LOW TIRE PRESSURE TELLTALE UNTIL TIRE PRESSURE FALLS BELOW VALUES REQUIRED BY THE STANDARD.

GENERAL MOTORS IS RECALLING 276, 729 MY 2009 BUICK ENCLAVE, CHEVROLET COBALT, HHR, MALIBU, TRAVERSE, GMC ACADIA, PONTIAC G5, G6 AND SATURN AURA AND OUTLOOK PASSENGER VEHICLES. THESE VEHICLES FAIL TO COMPLY WITH FEDERAL MOTOR VEHICLES SAFETY STANDARD 102, "TRANSMISSION SHIFT POSITION SEQUENCE, STARTER INTERLOCK, AND TRANSMISSION BRAKING EFFECT", AND FMVSS 114, "THEFT PROTECTION AND ROLLAWAY PREVENTION". ON SOME OF THESE VEHICLES, THE TRANSMISSION SHIFT CABLE ADJUSTMENT CLIP MAY NOT BE FULLY ENGAGED. IF THE CLIP IS NOT FULLY ENGAGED, THE SHIFT LEVER AND THE ACTUAL POSITION OF THE TRANSMISSION GEAR MAY NOT MATCH. WITH THIS CONDITION, THE DRIVE COULD MOVE THE SHIFTER TO "PARK" AND REMOVE THE IGNITION KEY, BUT THE TRANSMISSION GEAR MAY NOT BE IN "PARK".

DORMAN IS RECALLING 979 STEERING KNUCKLES, DORMAN P/NOS. 697-902 AND 697-903, SOLD UNDER DORMAN'S "OE SOLUTIONSTM " BRAND NAME, AND NAPA P/NOS. 7-8502 AND 7-8503 WHICH WERE SOLD FOR REPLACEMENT USE ON THE VARIOUS VEHICLES LISTED ABOVE. A POTENTIAL MATERIAL OR DESIGN DEFECT COULD RESULT IN THE STEERING KNUCKLE BREAKING IN THE HUB AREA.

ON CERTAIN PASSENGER VEHICLES, THE REAR AXLE PINION SEAL DOES NOT MEET ALL OF THE SPECIFICATIONS AND MAY EXPERIENCE A FLUID LEAK.

CERTAIN PASSENGER VEHICLES NOT EQUIPPED WITH OPTIONAL ROOF RAIL AIRBAGS OR OPTIONAL SUNROOF FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 201,"OCCUPANT PROTECTION IN INTERIOR IMPACT." DURING NHTSA IMPACT TESTS, THE INTERIOR OCCUPANT PROTECTION TEST POINTS EXCEEDED THE STANDARD REQUIREMENTS.

CERTAIN PASSENGER VEHICLES FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 207, "SEATING SYSTEMS." AND STANDARD NO. 210, "SEAT BELT ASSEMBLY ANCHORAGES." THESE VEHICLES MAY HAVE ONE TO FOUR INBOARD SEAT STUD FASTENERS THAT DO NOT MEET SPECIFICATION FOR STRENGTH.

CERTAIN SPORT UTILITY VEHICLES FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 208, "OCCUPANT CRASH PROTECTION." IN THESE VEHICLES, THE RIGHT FRONT PASSENGER SEAT IS BUILT WITH A PASSENGER SENSING SYSTEM. WHEN TESTED WITH A REPRESENTATIVE UNRESTRAINED SMALL ADULT, THE SYSTEM IS REQUIRED TO TURN THE RIGHT FRONT PASSENGER'S FRONTAL AIRBAG ON. AN ERROR IN THE SEAT SENSOR CALIBRATION CAN CAUSE IT TO FAIL THIS TEST. IN ADDITION, THIS CONDITION CAN PREVENT THE AIRBAG FROM TURNING OFF WHEN THE SEAT IS OCCUPIED BY A SMALL CHILD.

CERTAIN VEHICLES FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 212, "WINDSHIELD MOUNTING." AN INCORRECT PRIMER MAY HAVE BEEN USED WHEN INSTALLING THE WINDSHIELD. THE SAME PRIMER MAY HAVE ALSO BEEN APPLIED TO THE LIFTGATE GLASS AND THE SIDE STATIONARY GLASS.

CERTAIN 2 DOOR COUPE AND CONVERTIBLE PASSENGER VEHICLES MAY HAVE BEEN SUPPLIED WITH A TAILPIPE THAT MAY HAVE BEEN PRODUCED WITH A WELD LOCATED BETWEEN THE FASTENING CLIP AND EXHAUST PIPE, WHICH IS INADEQUATELY DIMENSIONED.

CERTAIN TRUCKS AND SPORT UTILITY VEHICLES FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 110, "TIRE SELECTION AND RIMS". THESE VEHICLES WERE SHIPPED WITH TIRE AND LOADING INFORMATION LABELS LISTING AN INACCCURATE VEHICLE CAPACITY WEIGHT.