Ford F-150 Recalls

On certain passenger cars, sport utility vehicles, and light and medium duty pickup trucks, a switch located in the plastic cover of the wiper motor gear case could malfunction and overheat, potentially resulting in loss of intermittent wiper function, loss of wiper park function, complete loss of wiper function, smoke, or ignition of the plastic cover material. Switch malfunction is most likely to occur when the intermittent setting of the wipers is being used, or when snow or ice obstructs the blades from returning to the "parked" position at the bottom of the windshield. These vehicles were built at the following assembly plants: Atlanta plant from 2/11/00 through 7/31/00; Chicago plant from 2/14/00 through 8/4/00; Kansas City plant from 2/26/00 to 9/4/00; Kentucky truck plant from 2/18/00 to 8/31/00; Michigan truck plant from 2/23/00 through 8/3/00; Norfolk plant from 2/21/00 through 7/27/00; Wayne Stamping and Assembly plant from 2/25/00 through 8/15/00; and Wixom plant from 2/...

The speed control cable can interfere with the speed control servo pulley and not allow the throttle to return to idle when disengaging the speed control. If the speed control is used and this condition is present, a stuck throttle could result, increasing the potential for a crash.

Certain sport utility vehicles, pickup trucks, and passenger vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard No. 225, "Child Restraint Anchorage Systems." The affected Expedition/Navigator owner guides do not identify the locations of seating positions equipped with tether anchorages and do not provide instructions for securing child seats to these tether anchorages. The F150 Owner Guides do not provide the procedure for securing child seats to the tether anchorages. The Taurus/Sable owner guides do not identify the center rear seating position as having LATCH-compatible lower anchorages. In the event of a crash, the child seat may not be properly attached, increasing the risk of injury to the child.

Certain bi-fuel CNG pickup trucks and vans, modified by CFI Control Systems, Inc., fail to conform to the requirements of FMVSS No. 303, "Fuel System Integrity of Compressed Natural Gas Vehicles." The label affixed to the fuel filler door by the vehicle modifier contains the inspection date and expiration date of the CNG tank. However, it does not contain the statement "See instructions on the fuel container for inspection and service life."

On certain passenger and sport utility vehicles, pickup trucks, and minivans equipped with seat belts supplied by TRW, it is possible that the driver's and/or outboard front passenger's seat belt buckle may not fully latch In the event of a crash, the restraint system may not provide adequate occupant protection, increasing the risk of personal injury to the seat occupant. The vehicles equipped with these belts include Ford Crown Victorias built at St. Thomas Assembly Plant from 4/17/00 - 5/29/01; Mercury Grand Marquis built at St. Thomas Assembly Plant from 4/17/00 - 5/29/01; Lincoln Town Cars built at Wixom Assembly Plant from 3/27/00 - 5/30/01; Lincoln Navigators built at Michigan Truck Plant from 4/11/00 - 5/31/01; Ford Windstars built at Oakville Assembly Plant from 3/23/00 - 5/30/01; Ford Rangers built at Twin Cities Plant from 3/28/00 - 5/30/01 and also at the Edison Plant from 3/13/00 - 5/25/01; Ford F-150 trucks built at the Norfolk Plant from 4/18/00 - 5/25/00, at the Onta...

Ford Motor Company (Ford) is recalling certain 2023-2027 F-150 vehicles. The fuel tank may be improperly secured and leak fuel, or detach from the vehicle while driving.

Ford Motor Company (Ford) is recalling certain 2026 F-150 vehicles. Incorrect rear axle tail bearings may have been installed, which can result in rear wheel lock-up or driveshaft separation.

Ford Motor Company (Ford) is recalling certain 2026 F-150 vehicles.The stabilizer rod fasteners may not have been tightened properly during manufacturing, which can allow the rod to shift out of position.

Ford Motor Company (Ford) is recalling certain 2026 Maverick, F-150, and Bronco Sport vehicles. Certain vehicle joints may be improperly tightened. This can lead to detached parts, unsecured cargo, degraded crash protection, electrical system failure, or a loss of vehicle stability.

Ford Motor Company (Ford) is recalling certain 2021-2023 F-150 and 2023-2026 F-250 SD vehicles equipped with 8-inch SYNC infotainment screens. A software error may cause the rearview camera image to be obstructed by the infotainment home screen menu when the vehicle is placed in reverse. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard (FMVSS) number 111, "Rear Visibility."