2004 Ford F-250 Recalls
Make selection is required
NHTSA safety recall results (2)
Recall information provided by National Highway Traffic Safety Administration
Component not known
- Recall date
- Recall no.
- 04V229
Certain pickup trucks fail to comply with the requirements of Federal Motor Vehicle Safety Standard No. 120, "Tire Selection and Rims for Motor Vehicles other than Passenger Cars." Some trucks were inadvertently equipped with an incorrect load range tire. This would result in incorrect tire load ratings. Also, the tire may be inflated above the maximum appropriate inflation pressure. If a tire were operated in an over-loaded or over-inflated condition, the tire may fail, resulting in a rapid air loss, which can cause a crash.
- Recall consequence
- Recall action
- Dealers will inspect and, if necessary, replace any incorrect load range tires. Additionally, if any tire is replaced, Ford recommends that the wheel lug nut torque be checked within 500 miles after any tire replacement. The manufacturer has reported that owner notification began on May 21, 2004. Owners may contact Ford at 1-800-392-3673.
Electrical system: Wiring
- Recall date
- 2005-06-07
- Recall no.
- 05V270000
CERTAIN PICKUP TRUCKS, SPORT UTILITY VEHICLES AND VANS EQUIPPED WITH 6.0L DIESEL ENGINES MAY EXPERIENCE STALLING WITHOUT WARNING WHILE DRIVING AND MAY OR MAY NOT RESTART.
- Recall consequence
- SHOULD THE ENGINE STALL, A VEHICLE CRASH COULD OCCUR.
- Recall action
- DEALERS WILL UPGRADE THE FUEL INJECTION CONTROL MODULE (FICM) WIRE HARNESS OR REPLACED, AND/OR HAVE A NEW INJECTION CONTROL PRESSURE (ICP)) SENSOR CONNECTOR INSTALLED. THE RECALL IS EXPECTED TO BEGIN ON JULY 5, 2005. OWNERS SHOULD CONTACT FORD AT 1-800-392-3673.
-
Prev - 1
-
Next