Dodge Recalls

Chrysler is recalling certain model year 2009-2012 Ram 1500 trucks manufactured from February 27, 2008, through June 30, 2009, and from December 1, 2009, through October 20, 2011; model year 2009-2011 Dodge Dakota trucks manufactured from February 27, 2007, through June 30, 2009, and from December 1, 2009, through September 30, 2011; model year 2009 Chrysler Aspen trucks manufactured from January 3, 2008, through December 18, 2008; and model year 2009 Dodge Durango trucks manufactured from January 3, 2008, through December 18, 2008. The rear axle pinion nut may loosen due to an undersized pinion spline that can allow relative motion between the nut and companion flange.

Chrysler is recalling certain model year 2013 Durango vehicles manufactured April 27, 2012, through September 14, 2012. The vehicles may have been built with incorrect seating capacity information labels. The label might overstate the seating capacity. Therefore, these vehicles fail to comply with the requirements of FMVSS number 110 "Tire Selection and Rims."

Chrysler is recalling certain model year 2009-2010, Ram 1500 and Dodge Dakota trucks, manufactured from July 1, 2009, through November 30, 2009, because a rear axle pinion nut may loosen due to a lack of adhesive.

Chrysler is recalling certain model year 2013 Dodge Durango vehicles manufactured from April 11, 2012, through July 20, 2012. Some vehicles may have been built with the incorrect airbag occupant restraint control (ORC) module.

CHRYSLER IS RECALLING CERTAIN MODEL YEAR 2012 TOWN AND COUNTRY AND DODGE GRAND CARAVAN VEHICLES, MANUFACTURED FROM MARCH 9, 2012 THROUGH MARCH 12, 2012. SOME VEHICLES MAY BE EQUIPPED WITH A RIGHT SIDE LIFTGATE PINCH SENSOR THAT DOES NOT FUNCTION PROPERLY. AS A RESULT, INCREASED FORCE MAY BE REQUIRED IN ORDER TO STOP THE POWER LIFTGATE DURING FINAL CLOSING STAGES.

CHRYSLER IS RECALLING CERTAIN MODEL YEAR 2011 AND 2012 300 AND DODGE CHARGER VEHICLES. THESE VEHICLES MAY LOSE ABS/ESC SYSTEM FUNCTION DUE TO AN OVERHEATED POWER DISTRIBUTION CENTER.

CHRYSLER IS RECALLING CERTAIN MODEL YEAR 2012 TOWN AND COUNTRY AND DODGE GRAND CARAVAN VEHICLES MANUFACTURED FROM NOVEMBER 15, 2011, THROUGH NOVEMBER 21, 2011. SOME VEHICLES MAY BE EQUIPPED WITH RIGHT REAR HUB AND BEARING ASSEMBLIES THAT WERE NOT FULLY MACHINED.

CHRYSLER IS RECALLING CERTAIN MODEL YEAR 2012 DODGE CHARGER SRT8 AND THE CHRYSLER 300 SRT8 VEHICLES MANUFACTURED FROM MAY 2, 2011, THROUGH NOVEMBER 17, 2011, FOR FAILING TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NUMBER 138, "TIRE PRESSURE MONITORING SYSTEM" (TPMS). AS BUILT, THE TPMS DOES NOT WARN THE DRIVER WHEN A TIRE IS 25 PERCENT BELOW THE RECOMMENDED PRESSURE. THE RECALLED VEHICLES NOTIFY THE CUSTOMERS WHEN THE TIRE PRESSURE REACHES 22 PSI RATHER THAN THE REQUIRED 24 PSI.

CHRYSLER IS RECALLING CERTAIN MODEL YEAR 2012 DODGE JOURNEY AND FIAT 500 VEHICLES MANUFACTURED FROM OCTOBER 24, 2011, THROUGH OCTOBER 26, 2011. SOME VEHICLES WERE ASSEMBLED WITH CONTAMINATED BRAKE FLUID AND MAY EXPERIENCE A DEGRADATION OF THE SEALING COMPONENTS WITHIN THE BRAKE SYSTEM.

CHRYSLER IS RECALLING CERTAIN MODEL YEAR 2012 CHRYSLER VEHICLES, INCLUDING 200 AND TOWN AND COUNTRY MODELS, DODGE VEHICLES, INCLUDING CHARGER, DURANGO, GRAND CARAVAN AND JOURNEY MODELS AND JEEP GRAND CHEROKEE VEHICLES MANUFACTURED FROM AUGUST 31, 2011, THROUGH SEPTEMBER 13, 2011, THAT ARE EQUIPPED WITH 3.6L ENGINES. THESE ENGINES MAY EXPERIENCE CONNECTING ROD BEARING FAILURE DUE TO DEBRIS INSIDE THE ENGINE BLOCK.